Loading the model…正在加载模型…
Robot duck机器鸭
Microduck
Build route组装方案 v1 · Feetech HD1910
A 26 cm robot duck that walks, rolls and gets back up. You print its body, buy the electronics and put it together.一只 26 cm 高的机器鸭，会走、会滑，摔倒了能自己站起来。身体自己打印，电子件买来，再亲手组装。
- Tall高度
- 26 cm
- Motors电机
- 15
- Printed parts打印件
- 36
Designed by 由 Pollen Robotics. 设计。Build route v1 by Nosca.组装方案 v1 由造物港提供。
About this model关于这个模型
- Motors电机
- 15 × Feetech HD-1910
- Compute主控
- Radxa ZERO 3W + robot HAT + IMU boardRadxa ZERO 3W + 机器人 HAT 扩展板 + IMU 板
- Power供电
- NP-F550 battery, charged outside the robotNP-F550 电池，在机器人外充电
- Size尺寸
- 144 × 141 × 264 mm
- 3D model3D 模型
- Shapes from the original design (外形来自原始设计（fanhao375 v1.0 exportfanhao375 v1.0 导出). The build route changes the servo horns and a few brackets.）。组装方案改了舵盘和几个支架。
- Licence许可证
- CC BY-NC-SA 4.0 model files · Apache-2.0 code模型文件 CC BY-NC-SA 4.0 · 代码 Apache-2.0
Sources来源
Get the parts配齐零件
Get the servos. Tap a line to find it on the model.先买舵机。点一行，就能在模型上找到它。
Battery and charger are sold separately. Use an NP-F550 battery and matching charger; check the holder fit and connector before buying.电池和充电器另购。请用 NP-F550 电池和配套充电器；购买前确认电池座尺寸和接头。
Parts零件 19
Bearings, screws and small parts轴承、螺丝和小零件 6
Need a different set of parts?需要别的零件组合？ Ask for parts咨询零件
Printed parts打印件 36
Build it动手组装
Two stages: put it together, then make it walk.分两个阶段：先组装，再让它走起来。
To see how the pieces fit, drag the slider under the model.想看零件怎么装在一起，就拖动模型下方的滑块。